Search results for "solid acid"
showing 7 items of 7 documents
Nanoporous alumina membranes filled with solid acid for thin film fuel cells at intermediate temperatures
2004
Thin film fuel cells have been fabricated by impregnation of inorganic porous membranes with inorganic proton conductor. Anodic alumina membranes (50 μm thick and pore diameter of 200 nm), filled with CsHSO4 salt have been used as protonic conductor in a hydrogen-oxygen fuel cell working between 423 and 443 K in dry atmosphere. Polarization curves at 433 K showing ohmic control with open circuit values near 0.8 V and short circuit current around 8 mA cm−2 have been obtained. Possible causes of degradation as well as alternative routes to overcome some of the problems encountered with this approach will be reported. Keywords: Solid acid, Anodic alumina membranes, Pore filling, Thin film fuel…
Dehydration of Fructose to 5-HMF over Acidic TiO2 Catalysts
2020
Different solid sulfonic titania-based catalysts were investigated for the hydrothermal dehydration of fructose to 5-hydroxymethylfurfural (5-HMF). The catalytic behavior of the materials was evaluated in terms of fructose conversion and selectivity to 5-HMF. The surface and structural properties of the catalysts were investigated by means of X-ray diffraction (XRD), N2 adsorption isotherms, thermo-gravimetric analysis (TGA), X-ray photoelectron spectroscopy (XPS) and acid capacity measurements. Special attention was focused on the reaction conditions, both in terms of 5-HMF selectivity and the sustainability of the process, choosing water as the solvent. Among the various process condition…
Size-confinement of CsH2PO4 in anodic alumina membranes for thin film electrolyte solid acid fuel cell
2007
Hemicellulose hydrolysis catalysed by solid acids
2013
Depolymerising hemicellulose into platform sugar molecules is a key step in developing the concept of an integrated biorefinery. This reaction is traditionally catalysed by either enzymes or homogeneous mineral acids. We compared various solid catalysts for hemicellulose hydrolysis, running reactions in water, under neutral pH and relatively mild temperature and pressure (120°C and 10 bar) conditions. Sulphonated resins are highly active, but they leach out sulphonic groups. Sulphonated silicas are less active, but more stable. They have weakly and strongly bound sites and the strongly bound ones do not leach. Zeolites are moderately active and stable. Among them, H-ferrierite especially, d…
Enhanced Heterogeneous Catalytic Conversion of Furfuryl Alcohol into Butyl Levulinate
2014
We study the catalytic condensation of furfuryl alcohol with 1-butanol to butyl levulinate. A screening of several commercial and as-synthesized solid acid catalysts shows that propylsulfonic acid-functionalized mesoporous silica outperforms the state-of-the-art phosphotungstate acid catalysts. The catalyst is prepared via template-assisted sol-gel polycondensation of TEOS and MPTMS. It gives 96 % yield (and 100 % selectivity) of butyl levulinate in 4h at 110 °C. Reaction profiles before and after a hot filtration test confirm that the active catalytic species do not leach into the solution. The catalyst synthesis, characterization, and mode of operation are presented and discussed. Sour ca…